Remote Control - Kenmore 580.75052 Owner's Manual

REMOTE CONTROL
Note:
The Remote Controller will not operate properly if strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote Control and the Air Conditioner.
Every time you push button, you will hear a beep from the Air Conditioner.
POWER
• To turn the air conditioner ON, push the button. To turn the air
conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High fan
speed, Temperature setting at 72°F.
TEMPERATURE SETTING
• This button can automatically control the temperature
of the room. The temperature can be set within a range of
60°F to 86°F by increments of 1°F.
FAN SPEED
• Every time you push this button, it advances the setting as
follows: {High i_ Low i, Med i_ High}
SLEEP
• Press the SLEEP button to set the time you want the unit to
turn off automatically.
• For your sleeping comfort, once Timer is set, the temperature
setting will raise by 2F after 30 min., and 2°F after another 30
min.
• Every time you push this button, the remaining time will be set
as follows.(1 Hour _,2Hours _.3 Hours _,4 Hours t, 5 Hours t,
6 Hours _ 7 Hours _,0 Hour _,1 Hours _,2 Hours _,.... )
TIMER
- SHUT-OFF TIME
• If unit is running, Timer sets number of hours until shut-off.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour _2 Hours _,etc. _ 12 Hours
maximum.
S
- START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Every time you push Timer button, it advances the Timer setting as
follows: 1 Hour _.2 Hours _.etc. _,12 Hours maximum.
• TEMP •
FAN SPEED
SLEEP MODE
TIMER
MODE
- Every time you push this button, it will shift among COOL, ENERGY SAVER and FAN.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is needed.
-11 -