Water Filtration And Monitoring System - KitchenAid 2200139A Use And Care Manual

To dispense water:
1. Press a glass against the water dispenser lever.
2. Remove the glass to stop dispensing.
NOTE: Dispense enough water every week to maintain a
fresh supply.
The dispenser light
The dispenser area has a light. It can be turned on
manually by pressing the "ON" button at the right hand
side of the control panel. The red indicator above the "ON"
button will appear. On some models: Whenever you use
the dispenser the lever will automatically turn the light on.
LIGHT
OFF
NOTE: See the "Changing the Light Bulbs" section for
information on changing the dispenser light bulb.
On models without crushed ice, the light switch is a
rocker-style type. Push the switch to turn the light on, and
push again to turn the light off.
The dispenser lock
(on some models)
Your dispenser can be turned off for easy cleaning or to
prevent accidental dispensing by small children and pets.
To turn off the dispenser, press the LOCK button. The
indicator will appear above the LOCK button and the ice
and water dispensers will not work. To unlock the
dispenser, press the UNLOCK button until the indicator
appears. Then continue to dispense ice or water as usual.
DISPENSER
LOCK
NOTE: The lock feature does not shut off power to the
product, to the ice maker, or to the dispenser light. It
simply deactivates the dispenser levers.
ON
UNLOCK
Water Filtration and
Monitoring System
(on some models)
The water filter indicator light
The water filter indicator light will help you know when to
change your water filter cartridge. The light is located at
the top of the refrigerator compartment. The light will
change from green to yellow. This tells you that it is almost
time to change the water filter cartridge (90% of the filter
life has been used). It is recommended that you replace
the water filter cartridge when the water filter indicator light
changes to red OR water flow to your water dispenser or
ice maker decreases noticeably. (See "Changing a water
filter cartridge" later in this section.)
NOTE: Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system.
After changing the water filter cartridge, reset the water
filter indicator light by pressing the light switch 5 times
within 10 seconds. The indicator light will change from red
to green when the system is reset.
Changing a water filter cartridge
The water filter is located below the freezer compartment
door.
1. Locate the water filter cartridge cap in the front base
grille below the freezer compartment door. Rotate the
cap counterclockwise to a vertical position and pull the
cap and filter cartridge out through the base grille.
NOTE: There will be water in the cartridge. Some
spilling may occur.
17