Jenn-Air w10519943b Use & Care Manual page 4

• Toensure p roper ventilation foryour i cemaker, thefront s ide
must b ecompletely unobstructed. The icemaker may be
closed-in onthetopandthree sides, buttheinstallation
should allow theicemaker tobepulled f orward f orservicing
ifnecessary.
• Installation oftheicemaker requires acold water s upply i nlet
of1/4" (6.35 mm) O D softcopper tubing withashutoff valve or
aWhirlpool supply l inePart N umber 8212547RB, anda
Whirlpool approved drain pump, Part N umber 1901A, only to
carry thewater t oanexisting d rain.
• Choose a well v entilated area withtemperatures above 5 5°F
(13°C) andbelow 110°F ( 43°C). Best r esults a reobtained
between 70°F and90°F (21°C and 32°C).
• The icemaker must b einstalled inanarea sheltered from the
elements, such aswind, r ain, w ater s pray, ordrip.
• When installing theicemaker under a counter, follow the
recommended opening d imensions shown. Place electrical
andplumbing fixtures i ntherecommended location a s
shown.
NOTES:
• Check that the power supply cord is not damaged, or
pinched or kinked between the ice maker and the
cabinet.
• Check that the water supply line is not damaged, or
pinched or kinked between the ice maker and the
cabinet.
• Check that the drain line (on some models) is not
damaged, or pinched or kinked between the ice maker
and the cabinet.
34"
(86.4 cm)
Min.
341/2"
(87.6 cm)
Max.
cm)
281/2"
(72.4 cm)
A
B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your ice maker into its final location, it is
important to make sure you have the proper electrical
connection:
A 115 volt, 60 Hz., AC only, 15- or 20-amp electrical supply,
properly grounded in accordance with the National Electrical
Code and local codes and ordinances, is required.
It is recommended that a separate circuit, serving only your ice
maker, be provided. Use a receptacle which cannot be turned off
by a switch or pull chain.
IMPORTANT: If this product is connected to a GFCI (Ground
Fault Circuit Interrupter) equipped outlet, nuisance tripping of the
power supply may occur, resulting in loss of cooling. Ice quality
may be affected. If nuisance tripping has occurred, and if the
condition of the ice appears poor, dispose of it.
Recommended Grounding Method
The ice maker must be grounded. The ice maker is equipped with
a power supply cord having a 3 prong grounding plug. The cord
must be plugged into a mating, 3 prong, grounding-type wall
receptacle, grounded in accordance with the National Electrical
Code and local codes and ordinances. If a mating wall receptacle
is not available, it is the personal responsibility of the customer to
have a properly grounded, 3 prong wall receptacle installed by a
qualified electrician.
A. Recommended location for electrical and plumbing fixtures
B. Floor level
Choose a location where the floor is even. It is important for
the ice maker to be level in order to work properly. If needed,
you can adjust the height of the ice maker by changing the
height of the leveling legs. See "Leveling."