IBM Nortel Networks L2/3 Manual page 86

1003 token-ring-default
1004 fddinet-default
1005 trnet-default
VLAN Type SAID
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
1 enet 100001
5 enet 100005
10 enet 100010
20 enet 100020
VLAN Type SAID
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
99 enet 100099
1002 fddi 101002
1003 tr
1004 fdnet 101004
1005 trnet 101005
Remote SPAN VLANs
------------------------------------------------------------------------------
Primary Secondary Type
------- --------- ----------------- ------------------------------------------
Note: If there are any unwanted VLANs, you can remove them with the no vlan #
command (where # is the number of the VLAN to remove). The VLAN information is not
included when dumping the switch configuration with the sh run command. VLAN
information is stored separately in a vlan.dat file.
Example 7-3 creates IP interfaces to be used later.
Example 7-3 Create IP addresses
interface Vlan10
ip address 10.10.0.245 255.255.255.0
interface Vlan20
ip address 10.20.0.245 255.255.255.0
interface Vlan99
ip address 10.99.0.245 255.255.255.0
Important: When looking at the configuration commands presented, commands toward
the left margin are for Core1 or GbESM_1 switches. Where the GbESM_2 or Core2 switch
configurations differ, the commands presented within comment syntax (/* for GbESM, !
for Cisco, # for Extreme) are for the counterpart switch of the same type, GbESM_2 or
Core2.
To start setting up the ports:
1. Access the interface level for g0/1 and g0/2 with the following:
interface range g0/1-2
Nortel Networks L2/3 Ethernet Switch Module for IBM Eserver BladeCenter
72
MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
1500 -
1500 -
1500 -
1500 -
MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
1500 -
1500 -
101003 1500 -
1500 -
1500 -
act/unsup
act/unsup
act/unsup
- - - -
- - - -
- - - -
- - - -
- - - -
- - - -
- - - -
- - ieee -
- - ibm -
Ports
! ip address 10.10.0.246 255.255.255.0
! ip address 10.20.0.246 255.255.255.0
! ip address 10.99.0.246 255.255.255.0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0