Check Bios Message - Maxtor SATA/300 PCI CARD Installation Manual

MAXTOR SATA/300 PCI CARD INSTALLATION GUIDE

Check BIOS Message

Power on your system and look for an on-screen BIOS message (see Figure 9) that refers to the Maxtor SATA/300 PCI
Card. This message indicates that the card has been properly detected by your motherboard. If you do not see this
message, turn off your system and make sure that the card is seated properly in the PCI slot.
The SATA/300 PCI Card is a PCI Plug-n-Play (PnP) device that automatically detects attached hard drives. In most cases, you will
not need to make changes in the motherboard BIOS Setup utility; however, on some newer systems, you may be able to set the
boot order of SATA devices in the motherboard's BIOS Setup. For more information on BIOS Setup, consult your system manual
or the system manufacturer.
FIGURE 9
SATA/300 PCI CARD BIOS MESSAGE
ENGLISH - PAGE 9