Connecting An Ultra Ata Hard Drive - Maxtor SATA/300 PCI CARD Installation Manual

MAXTOR SATA/300 PCI CARD INSTALLATION GUIDE

Connecting an Ultra ATA Hard Drive

The SATA/300 PCI Card has one Ultra ATA/133 port that supports up to two Ultra ATA/IDE hard drives on a single
80-conductor, 40-pin Ultra ATA cable (sold separately) . The card does not support ATAPI devices such as Zip drives or
CD/DVD drives. For maximum compatibility and data integrity, Maxtor strongly recommends that you do not use older
40-conductor ATA/IDE cables with this card.
1. Configure the jumpers of the Ultra ATA hard drive to the cable select setting. If you are connecting two Ultra ATA
drives, they should both be configured to the cable select (CS) setting. Consult the drive label, documentation, or
manufacturer for jumper configuration information. Jumper settings for popular Maxtor models are shown below
in Figure 7.
Style A1
(Includes
DiamondMax 16)
Style A2
(Includes DiamondMax
Plus 9, 10 or 11)
Master
Slave
Cable
Select
JUMPER BLOCK POSITIONS
Style B
(Includes DiamondMax
Plus 8 and Fireball 3)
Cylinder
Limitation
Jumper (CLJ)
(not for use
with this card)
FIGURE 7
Style C
(Models D740X-6L
and D540X-4K)
Master
Slave
Cable
Select
ENGLISH - PAGE 7