Connecting A Sata Hard Drive - Maxtor SATA/300 PCI CARD Installation Manual

MAXTOR SATA/300 PCI CARD INSTALLATION GUIDE

Connecting a SATA Hard Drive

Each of the two SATA/300 ports on the SATA/300 PCI Card supports a single SATA hard drive. To connect a SATA drive
to the card:
1. Attach one end of a SATA interface cable to one of the SATA connectors on the card. (See Figure 5 on page 5.)
2. Attach the other end of the SATA interface cable to the SATA connector on the rear of the hard drive.
SATA
PAGE 6 - ENGLISH
Power
Connector
POWER
SATA Interface
Connector
FIGURE 6
ATTACHING CABLES TO SATA DRIVE
NC
no connect
Note: The NC jumper pins have no
function. They are used only for
spare jumper storage.
Force 150
The Force 150 jumper should be in
transfer speeds
the NC position when the drive is
connected directly to the Maxtor
SATA card.