Westinghouse POR663 User Manual page 17

CLEANING YOUR APPLIANCE
Re-assembling top door trim
• T ake hold of the top door trim at each side and
position it to the inside edge of the glass.
• P ush the trim down with its top edge over glass panel
until the clip snaps in on each side of the trim.
• P ush the middle of the trim down to ensure it is straight
and firm against the glass panel.
Fitting the oven door
• T ake hold of the oven door with a hand on each side
and with the door at an angle of 45º, position the
recesses at the bottom of the door onto the hinge arms
of the oven. Let the door slide down the hinge arms as
far as it will go.
CLEANING
32
• o pen the door fully to access the hinges then rotate
the 'stirrups' (see image below) until they lock into the
hook. The oven do or may now be closed.
hook stirrup
hook stirrup
Side open door
Side open door models have been designed to allow for
the inner glass panels to be removed for cleaning.
Removing side open door top trim
• T ake hold of the grid embossed sections of the door
trim at each end and press inwards to release the clips.
Then remove the door trim by lifting it upwards.
CLEANING YOUR APPLIANCE
Removing side open door glass panel
WARNING
Rough handling, especially around the edges can cause
the glass to break.
• T ake hold of the black bordered glass panel with a
hand on its upper and lower edge. Lift and rotate the
glass around the retainer to remove it from the guide.
• T ake hold of the smaller clear glass panel (when fitted)
with a hand on its upper and lower edge.
Lift the glass to remove it from the retainer.
• The rubber moulding on the upper corner of the small
clear glass panel may be removed. Please take care
that it is not misplaced.
Cleaning door glass panels
WARNING
Do not to use harsh abrasives on the glass panes as the
reflective surface plays a role in the function of
the oven.
Do not place glass in dishwasher. Hand wash only with a
soft cloth and warm soapy water. When dry polish with a
soft cloth and ensure the glass is dry before reassembly.
Re-assembling door glass panels
• e nsure the rubber moulding is on the upper corners of
the smaller clear glass panel.
• I nsert the smaller glass panel (when fitted) first from
above and at an angle to the profile of the door.
• R epeat for the black bordered glass panel ensuring
the painted surface is facing toward the outside of
the door.
33
CLEANING