Westinghouse POR663 User Manual page 16

CLEANING YOUR APPLIANCE
Cleaning oven door (except models POR883 & POR881)
WARNING
Do not lift the door by the handle. Rough handling will
cause glass to break.
Removing the oven door
Your oven is equipped with a door that can be
disassembled in order to clean all the panes of glass.
Remove the door before cleaning.
• o pen the door fully to access the hinges then rotate the
'stirrups' (highlighted in the image) on both hinges fully
towards the oven.
• S lowly close the oven door until it is stops against the
'stirrups' (about 45°).
CLEANING
30
• G rasp the oven door with a hand each side of the
door and remove it from the oven by pulling it
towards you.
• L ay the oven door with the outer side facing
downwards on something soft and flat (for example a
blanket on a kitchen table) to prevent scratches.
Removing oven door top trim
• T ake hold of the grid embossed sections of the door
trim at each end and press inwards to release the clips.
Remove the door trim by pulling it towards you.
Removing door glass panels
WARNING
Rough handling, especially around the edges can cause
the glass to break.
• L ift the black bordered glass panel out of
the guide.
• R epeat this for the smaller clear glass panel
(when fitted).
CLEANING YOUR APPLIANCE
Cleaning door glass panels
WARNING
Do not to use harsh abrasives on the glass panes as the
reflective surface plays a role in the function of the oven.
Do not place glass in dishwasher. Hand wash only with a
soft cloth and warm soapy water. When dry polish with a
soft cloth and ensure the glass is dry before reassembly.
Bottom trim (on selected models)
• T he bottom trim may be removed for cleaning by
snapping out and lifting away from the glass.
Re-assembling bottom trim
• P ush down to "snap" each side of bottom trim back
into door columns.
Re-assembling door glass panels
• I nsert the smaller clear glass panel (when fitted) first
from above and at an angle to the profile of
the door.
• R epeat for the black bordered glass panel ensuring the
painted surface is facing to the downside.
31
CLEANING