Westinghouse POR663 User Manual page 18

CLEANING YOUR APPLIANCE
Replacing top door trim
• T ake hold of the top door trim at each side and
position it to the inside edge of the glass.
• P ush the trim down with its top edge over glass panel
until the clip snaps in on each side of
the trim.
CLEANING
34
CLEANING THE PYROLYTIC OvEN DOOR
(POR883 & POR881 MODELS ONLY)
Your pyrolytic oven is equipped with an oven door that can
be disassembled in order to clean all the panes of glass.
Positioning the door for dismantling
The door needs to be positioned at an angle to aid in the
disassembly of the panes.
• o pen the oven door fully and flip out the locating tab
on each hinge to the open position.
• G ently close the oven door until it stops on the locating
tabs. The door is now ready for dismantling.
Removing the top door trim
• Push in the 2 buttons on either side of the trim.
• Lift the trim away from the door.
Removing the glass panes
• Remove the 3 panes of glass starting with pane 1.
• W hen removing pane 3 ensure that the 2 rubber supports
are removed before cleaning. Do not misplace them!
Cleaning the glass panes
Clean with a damp cloth.
Do not use scouring agents or abrasive sponges
as these could damage the reflective surface.
Dry thoroughly before reassembly.
Replacing the glass panes
• R eplace the glass panes back into the door starting
with pane 3.
• e nsure this pane is placed into the correct slot and that
the 2 rubber supports are in place.
• N ext replace pane 2. There is a reflective coating on
this pane. This coating is indicated by a circle printed
on its surface. ensure this circle is in the same corner as
pictured below.
Circle in this corner
• R eplace pane 1 ensuring the black screening is facing
inwards towards the oven.
Replacing the top door trim
Replace the trim ensuring the clips snap into the 2 location holes.
Open the oven door fully and return the locating tab on
each hinge to the original closed position.
CLEANING
35