Omega Excalibur ATV-1000 Manual page 25

disarm. With a custom-programmed Selectable Code Override of, for example, "3 and 9
presses", upon entering the vehicle and turning the ignition "on", the valet switch must be
pressed three times. This causes the audible output (i.e.- horn or siren) to stop sounding
and emit one chirp. The audible output then resumes, and the "stage 2" entry, nine presses
must be entered, which achieves an override and disarms the system. However, if either
entry is incorrect, the system will not disarm. If a customized valet switch entry is desired
for the Selectable Code Override, please note that the "stage 2" is also required.
To custom program the Selectable Code Override from the default setting, follow Steps
1 and 2, on pages 34-35. In Step 2, the valet switch will be pressed once. At Step 3, press
and release the transmitter's "arm/lock" button a number of times equal to the desired
Selectable Code Override for stage 1. The system will respond to each transmitter button
press with a siren chirp. After pressing the transmitter button the desired number of times,
wait for the system to chirp the siren again an equal number of times. Now press and
release the transmitter's "disarm/unlock" button a number of times equal to the desired
Selectable Code for stage 2. The system will again chirp the siren in the same fashion as
the code entered for stage 1.
Should the system have an unknown customized Selectable Override Code already
entered, the factory-set default of one press and no press can be obtained by reprogram-
ming this feature.
#2 Last Door Arming: Default OFF. This feature automatically arms the system upon
your exiting the vehicle, and is explained in detail on pages 7-8. If desired, having the
Page - 26