Table of Contents
Advertisement
Feature #2
This feature allows the option of a 30 or 60 second Alarm Duration, which is
when the system has been activated into an Alarm state, sounding the siren and
flashing the parking lights.
Changing the Alarm Duration:
Follow Steps 1 to 4 on page 27; at Step 4 the Valet Switch will be pressed and
released twice. The system's response will be two siren chirps, and the Status
Light flashing two times, pausing, then repeating. Within 10 seconds, press and
release the transmitter/transceiver's "Arm/Lock" button to set the Alarm Dura-
tion for 60 seconds (the siren will chirp once) or the "Disarm/Unlock" button to
set the Alarm Duration for 30 seconds (the siren will chirp twice).
Feature #3
This feature determines how long after the Arming confirmation chirp that
the system becomes fully Armed. The Arming Delay applies to the system
Arming regardless if it occurs from using the transmitter/transceiver, Last Door
Arming or Automatic Rearming.
Programming 3 / 45 Second Arming Delay:
Follow Steps 1 to 4 on page 27; at Step 4 the Valet Switch will be pressed and
released three times. The system's response will be three siren chirps, and the
Status Light flashing three times, pausing, then repeating. Within 10 seconds,
press and release the transmitter/transceiver's "Disarm/Unlock" button to config-
ure the system with a 45 second Arming Delay (the siren will chirp once) or the
"Arm/Lock" button to configure the system with a 3 second Arming Delay (the
siren will chirp twice).
Feature #4
This feature configures the system to automatically Arm itself 30 seconds
after the vehicle's last door is closed.
Programming Last Door Arming:
Follow Steps 1 to 4 on page 27; at Step 4 the Valet Switch will be pressed and
released four times. The system's response will be four siren chirps, and the
Status Light flashing four times, pausing, then repeating. Within 10 seconds,
press and release the transmitter/transceiver's "Arm/Lock" button to turn on Last
Door Arming (the siren will chirp once) or the "Disarm/Unlock" button to turn
off Last Door Arming (the siren will chirp twice).
30 or 60 Second Alarm Duration
(Factory Default Setting 30 Seconds)
3 / 45 Second Arming Delay
(Factory Default Setting 3 Second)
Last Door Arming
(Factory Default Setting Off)
Page 30
To Activate Remote Starting:
Press & Release the "Arm/Lock" Button (
J
Button (
) together
AND
AND
To remote start the vehicle:
1- Press and release together the transmitter or Echo transceiver's "Arm/Lock"
and "Disarm/Unlock" buttons. The system will respond first by rapidly
flashing the Status Indicator Light Green, then by turning on the ignition and
flashing the parking lights once.
2- The starter will engage until the engine runs; 10 seconds later the parking
lights will illuminate steady during the period that the engine is running
from being remotely started. (having them flash instead is an option).
If the Echo transceiver is used to activate remote engine starting feature, it
will further sequence status indications beyond what the system does in the
vehicle. When the Echo is used for remote starting:
• It will play a musical melody, and the "start" icon, puffs of smoke, appear
behind the vehicle (5 different musical melodies are programmable).
• Once the engine has started, when the vehicle's parking lights come back on
the "start: icon's puffs of smoke will change to appearing sequentially.
• When the engine stops running, whether by safety condition or transceiver
command, a different musical melody is played, and the "start" icon disap-
pears. If a safety circuit stops the engine, the "crossed out key" icon will
momentarily appear (but not if the transceiver's command stops the engine).
• If a safety circuit prevents the starting attempt, the "engine stopped" melody
will play, and the "crossed out key" icon will appear.
Once the engine has been remotely started, it will run for 10 minutes (an
optional 20 minute setting may be programmed). To remotely stop the engine
again press and release together the "Arm/Lock" and "Disarm/Unlock" buttons.
The system will stop the engine, and extinguish the parking lights.
•
When leaving the vehicle before remote starting, remember to set the climate
controls to the desired heating or air conditioning settings.
U
) and the "Disarm/Unlock"
THE PARKING LIGHTS
WILL ILLUMINATE*
THE ENGINE
STARTS
* FLASHING PARKING
LIGHTS IS OPTIONAL
Page 19
Advertisement
Table of Contents
