Installing Memory; Removing The Cover - Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual

Installing Memory

Disengage the latch and pull the power supply out by the handle. (See
Step 3
Figure 4-4
Within one minute, insert the new power supply with the surface marked "TOP" facing up and verify
Step 4
that the latch is engaged.
Insert the power cord into the replacement power supply.
Step 5
Check the power LED to verify that the new power supply is receiving power.
Step 6
If a power supply alarm occurs and you power down the WAVE appliance to replace the power supply,
Note
you must use the clear bmc event-log global configuration command and then reboot to clear the alarm.
Installing Memory
This section provides basic instructions for installing memory in your WAVE-594 and WAVE-694. It
contains the following topics:
•
•

Removing the Cover

Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Warning
Statement 1
Caution To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
4-6
Power Supply Assembly
Removing the Cover, page 4-6
Installing Memory Modules, page 4-7
Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694
Figure 4-4.)
OL-24619-02