Location Of Ports And Connectors - Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual

Chapter 1 Introducing the Cisco Wide Area Virtualization Engine 594 and 694
Table 1-2
LED
3 - 8

Location of Ports and Connectors

The WAVE appliance supports two Ethernet connectors and two Console ports on the front of the
appliance.
Figure 1-3
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
This section contains the following topics:
•
•
Ethernet Port Connectors
Connect a Category 3, 4, or 5 unshielded twisted-pair cable to an Ethernet connector. 100BASE-TX and
1000BASE-T Fast Ethernet standards require Category 5 or higher cabling.
The WAVE-594 and WAVE-694 appliance has two Ethernet connectors that are attached to the Ethernet
controllers (see
an interface for connecting to a 10-Mbps, 100-Mbps, or 1-Gbps network and provide full-duplex (FDX)
capability, which enables simultaneous transmission and reception of data on the network. If the
Ethernet ports in the server support auto negotiation, the controllers detect the data-transfer rate
(10BASE-T, 100BASE-TX, or 1000BASE-T) and duplex mode (full duplex or half duplex) of the
network and automatically operate at that rate and mode. You do not have to set any jumpers or configure
the controllers.
There is a third RJ45 connector on the front of the appliance (see
Note
not connect this port to your network.
OL-24619-02
Back Panel LEDs (continued)
Color
Fan status Orange
Orange
—
shows the back panel ports and connectors.
Ethernet Port Connectors
Console Port Connector
Figure 1-5). The Ethernet controllers are integrated on the system board. They provide
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
State Description
On Alarm.
Blinking Alarm. Fan speed too low.
Off Normal state.
Figure
Hardware Features
1-1). This is a console port. Do
1-5