Installing A Bri Wan Interface Card In A Router - Cisco WIC36-1B-S Configuration Note

Installing a BRI WAN Interface Card in a Router

Figure 3
Installing a BRI WAN Interface Card in a Router
Caution
inserting a WAN interface card into a 2-slot network module that is already installed in the router
chassis, you must turn OFF electrical power and disconnect network cables.
The following instructions apply only to installing a WAN interface card in a 2-slot network module.
If you need to install the 2-slot module in a chassis slot, see your router installation and configuration
guide.
You can install WAN interface cards either before or after mounting the router, whichever is more
convenient. You can install the card in the base module either before or after installing the base
module in the router chassis.
Note
Interface (PRI) network module. This configuration is not supported.
6
Termination Jumpers on the BRI S/T WAN Interface Card
J1
J2
Termination jumpers
WAN interface cards do not support online insertion and removal (hot swap). Before
Do not install a BRI WAN interface card in the same chassis as an ISDN Primary Rate
A
J1
J2
No termination
B
J1
J2
100 Ohms termination