Ports And Led Indicators - Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual

Ports and LED Indicators

Figure 5-7
Link/Activity
Table 5-2
Table 5-2
Name
NIC link/activity
NIC speed
Figure 5-8
designations, and LEDs.
Figure 5-8
The Interface Module has an LED that corresponds to each port.
Table 5-3
LED
1
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
5-6
Copper Interface Module—Gigabit Ethernet LEDs
LED
8 1
describes the Gigabit Ethernet port LEDs.
Copper Interface Module—Gigabit Ethernet LEDs
Color
Green
Green
—
—
Green
Yellow
shows the 4-port Fiber Optic Gibabit Ethernet Interface Module port numbers, interface
4-Port Fiber Optic Gigabit Ethernet Interface Module—Port Numbering and LEDs
GE 0 GE 1
A Status A Status
4 Port GE SX Inline
1 2 3
Fiber Optic Interface Module—Power and Status LEDs
Name Color
Interface Module Green
power LED
—
Speed LED
State Description
On Link exists.
Blinking Activity exists.
Off No link detected.
Off 10Mbps connection.
On 100Mbps connection.
On 1000Mbps connection.
GE 2 GE 3
A Status A Status
State Description
On Interface Module is receiving power.
Off Interface Module is not installed or a power
supply failure has occurred.
Chapter 5 WAVE Interface Modules
Table 5-3 describes the LEDs.
OL-24619-02