Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual page 55

Chapter 5 WAVE Interface Modules
Table 5-3
2
3
Figure 5-9
interface designations, and LEDs.
Figure 5-9
2 Port 10GE SFP+
The 2-Port Fiber Optic 10 Gigabit Ethernet SFP+ Interface Module does not support mechanical bypass.
Note
The Interface Module has an LED that corresponds to each port.
Table 5-4
LED
1
2
OL-24619-02
Fiber Optic Interface Module—Power and Status LEDs
Activity Green
Green
—
Bypass status Green
Amber
shows the 2-port Fiber Optic 10 Gibabit Ethernet SFP+ Interface Module port numbers,
2-Port Fiber Optic 10 Gigabit Ethernet SFP+ Interface Module—Port Numbering and
LEDs
2 3
A S
10GE 0
1 4
Inline Network Adapter LEDs
Name Color
Interface Module Green
Power LED
—
Activity —
Green
Green
Yellow
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
On Link exists.
Blinking Transmitting.
Off No link detected.
Normal Indicates the inline port pair is in interception
mode.
Bypass Indicates the inline port pair is in bypass
mode.
A S
10GE 1
State Description
On Interface Module is receiving power.
Off Interface Module is not installed or a power
supply failure has occurred.
Off No link is detected.
On Link is detected.
Blinking Transmitting.
On Interface Module is administratively shut
down.
Ports and LED Indicators
Table 5-4 describes the LEDs.
5-7