Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual page 70

Error Symptoms
Table 6-7
Symptom
The power-control button does
not work (the appliance does
not start).
Note
The appliance does not power
down.
The appliance unexpectedly
shuts down, and the LEDs on
the operator information panel
are not lit.
Table 6-8
Symptom
A console connection does not
work. For more information
about the console port, see the
"Console Port Connector"
section on page
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
6-8
Power Problems
FRU or Action
1.
The power-control
2.
button will not
function until 20
seconds after the
3.
appliance has been
connected to power.
1.
2.
3.
See the
Console Port Problems
FRU or Action
1.
2.
1-6.
Chapter 6
Verify the following items:
The power cables are properly connected to the appliance.
a.
The electrical outlet functions properly.
b.
If you just installed a hardware option, remove it, and restart the
appliance.
See the "Undetermined Problems" section on page
Turn off the appliance by pressing the power-control button for 5
seconds.
Restart the appliance.
If the power-control button does not work, disconnect the power
cord for 20 seconds. Reconnect the power cord and restart the
appliance.
"Undetermined Problems" section on page
Verify that the console device is connected to the correct port (see
the "Console Port Connector" section on page
If using the mini-USB console port, verify that the driver has been
installed (see the "Console Port Connector" section on page
Troubleshooting the System Hardware
6-4.
6-4.
1-6).
OL-24619-02
1-6).