Location Of Ports And Connectors; Ethernet Port Connectors - Cisco 7541 Hardware Installation Manual

Chapter 1 Introducing the Cisco Wide Area Virtualization Engine 7541, 7571, and 8541
Table 1-2
LED
1, 2
3- 11 Fan status

Location of Ports and Connectors

The WAVE appliance supports two Ethernet connectors and two Console ports on the front of the
appliance.
Figure 1-3
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
Warning
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when
connecting cables. Statement 1021
This section contains the following topics:
•
•

Ethernet Port Connectors

Connect a Category 3, 4, or 5 unshielded twisted-pair cable to an Ethernet connector. 100BASE-TX and
1000BASE-T Fast Ethernet standards require Category 5 or higher cabling.
The WAVE-7541, WAVE-7571, and WAVE-8541 appliance has two Ethernet connectors that are
attached to the Ethernet controllers (see
integrated on the system board. They provide an interface for connecting to a 10-Mbps, 100-Mbps, or
1-Gbps network and provide full-duplex (FDX) capability, which enables simultaneous transmission and
reception of data on the network. If the Ethernet ports in the server support auto negotiation, the
controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T) and duplex mode
(full duplex or half duplex) of the network and automatically operate at that rate and mode. You do not
have to set any jumpers or configure the controllers.
Back Panel LEDs
Color
Power supply status —
Red
Green
Green
Red
Red/Green
Orange
Orange
—
shows the back panel ports and connectors.
Ethernet Port Connectors
Console Port Connectors
Cisco Wide Area Virtualization Engine 7541, 7571, and 8541 Hardware Installation Guide
State Description
Off No AC power to all power supplies.
Blinking No AC power to this power supply.
Blinking AC power is present, only standby output on.
On Power supply DC outputs on and OK.
On Power supply failure. For more information,
see Chapter 6, "Troubleshooting the System
Hardware."
Blinking Power supply warning. For more information,
see Chapter 6, "Troubleshooting the System
Hardware."
On Alarm.
Blinking Alarm. Fan speed too low.
Off Normal state.
Figure 1-1 and Figure 1-2). The Ethernet controllers are
Hardware Features
1-5