Craftsman 137.375630 Operator's Manual page 19

Fig.G
4
ADJUSTING FOR
ANGLE CUTTING
(FIG. H)
1. Loosen the vise crank and back
the vise clamp (3) away from the
adjustable fence (2).
2. Loosen the two bolts (1) of the
adjustable fence with the cutting
wheel wrench.
3. Move the adjustable fence (2) to
the desired angle between 0 and
45 degrees.
4. Tighten the two bolts (1).
5. The vise clamp (3) will align itself
automatically with the angle of
the workpiece when clamping a
workpiece in position,
.
Raise the cutting arm up and lock
the fence into position.
Fig. H
2
3
1
4
CARRYING YOUR CHOP SAW
(FIG. I)
The chop saw can be transported to
any workplace conveniently by:
1. Lowering the cutting arm to its
lowest position and securing in
place by attaching the locking chain
(1) to the hook (2), located on the
motor housing.
2. Transport the saw using the
carrying handle (3)located above
the motor.
NOTE: To check the squareness of
the blade to the fence:
1. Loosen the vise crank and back the
vise clamp (3) from the adjustable
fence (2).
2. Loosen the two bolts (1) on the
adjustable fence with the cutting
wheel wrench.
3. Lower the cutting arm down until
the wheel (4) is below the base.
4. Place a square (5) against the
wheel and adjust the fence against
the square,
Fig. I
2
1