Advertisement
Available languages
Available languages
NOTE: Make sure the directional
arrow on the replacement wheel
matches the direction of the saw.
7.
Press the spindle lock (4). (Fig. E)
8.
Turn the arbor bolt (3) clockwise
until snug and tighten with the
cutting wheel wrench (2) provided.
(Fig. D)
9.
Make sure the wheel is secure.
10. Be sure the spindle lock (4)is
released so the abrasive cutting
wheel (5) turns freely by spinning
the cutting wheel until the spindle
lock (4) disengages.
11. Release the cutting wheel guard (1)
back to its original position. (Fig. C)
Fig. C
1
\
\
\
Fig. E
3
NOTE: If the cutting depth stop bolt
has been adjusted during operation of
the old abrasive wheel, reset for the
depth for a new 14 in. diameter wheel.
(See instructions on page 18)
Fig. D
Advertisement
