Brocade Communications Systems ServerIron ADX 12.4.00 Manual Manual page 42

1
Configuring GSLB protocol parameters
The <tcp-portnum> parameter specifies the TCP port number you want the ServerIron ADX to use
for exchanging GSLB information with other ServerIron ADXs.
If you change the GSLB protocol port number, you must write memory and reload the software to
place the change into effect. Also, you must change the port to the same number on all ServerIron
ADXs in the GSLB configuration. If the port number in two GSLB ServerIron ADXs is not the same,
those ServerIron ADXs are not able to properly perform GSLB.
Changing the GSLB protocol update period
The GSLB protocol update period specifies how often the site ServerIron ADXs report their session
table statistics and CPU utilization to the GSLB ServerIron ADX. The default update period is 30
seconds.
By default, each remote ServerIron ADX uses the GSLB protocol to send status information to the
GSLB ServerIron ADX every 30 seconds. The status information consists of session utilization and
CPU load information, which you can display using the show gslb site command (refer to
"Displaying site information"
You can change the period to a value from 1-300 seconds. The GSLB ServerIron ADX then informs
all the remote ServerIron ADXs of the change.
To change the GSLB protocol update period, enter the following commands on the GSLB ServerIron
ADX.
ServerIronADX(config)# gslb policy
ServerIronADX(config-gslb-policy)# protocol status-interval 10
The command changes the GSLB protocol update period to 10 seconds.
Syntax: [no] protocol status-interval <num>
The <num> parameter specifies the number of seconds between status reports and can be from
1-300 seconds. The default is 30 seconds.
To display the current update period, enter the show gslb policy command. The interval is shown in
the Remote ServerIron ADX status update period field. Refer to
on page 175 for more information.
Modifying GSLB parameters related to DNS responses
You can modify the following DNS-related GSLB parameters:
•
•
•
•
•
•
30
on page 165).
IP address for a site that fails a health check: refer to
a health check" on page 31.
IP addresses that pass the health checks but still are not selected as the "best" site: By
default, the ServerIron ADX leaves all the IP addresses in the DNS reply. You can configure the
ServerIron ADX to remove all addresses from the reply except the "best" address. Refer to
"Removing all addresses except the best address"
DNS record verification interval: refer to
TTL value the ServerIron ADX sets for the DNS records: refer to
records" on page 32.
If you prefer to manage the TTL values solely using the DNS server, you can disable TTL
modification on the ServerIron ADX. refer to
DNS override: refer to "Enabling DNS override"
"Displaying the default GSLB policy"
"Removing IP addresses for sites that fail
on page 31.
"Changing the query interval"
"Changing the TTL for DNS
"Disabling TTL modification"
on page 33.
ServerIron ADX Global Server Load Balancing Guide
on page 32.
on page 32.
53-1002437-01