Brocade Communications Systems ServerIron ADX 12.4.00 Manual Manual page 247

In the following example, the order has been changed, two of the metrics have been disabled, and
the administrative preference has been enabled.
ServerIronADX(config)# show gslb policy
Default metric order: DISABLE
Metric processing order:

DNS active-only: DISABLE
Modify DNS response TTL: ENABLE
DNS TTL: 10 (sec), DNS check interval: 30 (sec)
Remote ServerIronADX status update period: 30 (sec)
Session capacity threshold: 90%, session capacity tolerance: 10%
Round trip time tolerance: 10%, round trip time explore percentage: 5%
Round trip time cache prefix: 20, round trip time cache interval: 120 (sec)
Flashback appl-level delay tolerance: 10%, TCP-level delay tolerance: 10%
For a description of the information shown by this command, refer to
policy"
Syntax: show gslb policy
Displaying information about a geographic prefix
To view information about a specific geographic prefix, enter the following command on the GSLB
ServerIron ADX:
GSLB-ServerIronADX# show gslb ipv6 cache 2001:db8::
prefix length = 64, prefix = 2001:db8::, region = N-AM
prefix source = geographic (static),
Syntax: show gslb ipv6 cache [geographic (user-configured | static)]
The static option returns only those entries which were created internally by GSLB ServerIron ADX.
The user-configured option returns entries created by the user using the geo-prefix command.
Displaying results of traffic distribution for weighted sites
Use the show gslb traffic site command to view information about the domains hosted by each site.
For each domain name, the command shows that amount of traffic that was sent to each
ServerIron ADX in that site, and the total percentage of traffic sent to the site.
ServerIron ADX Global Server Load Balancing Guide
53-1002437-01
1-Round trip time between remote ServerIronADX and client
2-Remote ServerIronADX's session capacity threshold
3-Remote ServerIronADX's available session capacity
4-Server flashback speed
5-Remote ServerIronADX's preference value
6-Least response selection
on page 232.
Displaying GSLB for IPv6 configurations
DNS best-only: DISABLE DNS override: DISABLE
"Displaying the default GSLB
2
235