Using The Side Burner; Lighting Instructions; Match Lighting - DCS BGB131 Installation, Use & Care Manual

USING THE SIDE BURNER
LIGHTING INSTRUCTIONS
First remove the burner cover and any cooking utensils from the burner grate. Push and hold the ignition
button, turn the control knob to the "HI" position until the burner is lit or 4 seconds pass. If the burner doesn't
ignite, wait S minutes for any accumulated gas to dissipate then try again. If the burner will not light after
several attempts, check the troubleshooting instructions on page 16.
MATCH LIGHTING
Hold a lit fireplace match near the burner ports, turn the control knob counterclockwise to "HI". Rotate the knob
immediately once the burner is lit to the desired setting.
Note:
If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been
turned "off': This "extinction pop" is normal for propane gas.
RE_ IQNITIO. FRONT
/
/ \
Control Ignition
Knob Button
FIG. 09 BGB132 Shown
14