Safety Practices And Precautions - DCS BGB131 Installation, Use & Care Manual

SAFETY PRACTICES & PRECAUTIONS
Improper use or installation is dangerous. Carefully follow these instructions.
• AIways remove the cover before lighting the professional side burner. Never use the side burner ifaleakis
present.
• Do not use a flame to check for gas leaks.
• Do not let children use the side burner.
• Do not leave children unattended near the side burner.
• Never let children crawl or hang on the side burner.
• Exercise care when operating the side burner. The burner grate can get hot enough to cause burns during
operation.
• Never leave the side burner on unattended.
• Always wait 5 minutes before relighting the burner to allow any accumulated gas to dissipate. Should the burner
go out during use, turn off the gas valve and wait 5 minutes before attempting to relight. Always follow the
lighting instructions. Never lean overalit burner.
• Never cook without the drip pan in place, pushed all the way to the rear of the burner box.
• Use only in well ventilated areas.
• Do not use in garages, breezeways, sheds, or other such enclosed areas.
• Keep the area surrounding the side burner clear and free from combustible materials, gasoline, other flammable
liquids or vapors, charcoal lighter fluid, and trash.
• Do not obstruct the flow of combustion and ventilation air to the side burner. On cart mounted units, keep area
beneath the burner free of debris. If the burner is built-in, do not store gas cylinders beneath the unit without
adequate ventilation.
WARNING!
Do not store items of interest to children above or at the back of any appliance. Children could be seriously injured
if they should climb onto the appliance to reach these items.
• Keep the side burner covered when not in use.
• Never connect an unregulated gas line to the side burner.
• If the side burner has not been used for an extended period of time (over winter, for example) the unit should
be checked for gas leaks and obstructions in the burner.
• Thoroughly clean the side burner on a regular basis.
• Only use the side burner with the type of gas specified on the rating plate. To change from LP gas to natural, or
vice versa, a factory conversion kit (see page 10 for conversion kit information) is required.
NOTE:
This product must be instafled by a licensed plumber or gas fitter when installed within the Commonwealth of
Massachusetts.