Troubleshooting - Kenmore Freezer Owner's Manual

TROUBLESHOOTING
The freezer does not operate.
Check to make sure the freezer is plugged in at the
wall outlet.
If the plug is secure and the freezer stills fails to
operate_ plug a lamp or a small appliance into the
same outlet to determine if there is a tripped circuit
breaker or burned-out fuse.
Check to ensure the cold control knob is not set to
Position "0" (off).
The freezer runs too frequently or too long.
Excessive frost or a package may be holding the lid
open.
The temperature control knob has been reset to a
colder temperature setting.
The lid was opened too frequently or too long.
A large quantity of unfrozen food has recently been
added to the freezer.
The room temperature is unusually warm (extended
period of warm weather).
There is inadequate air circulation space behind the
cabinet. The freezer needs proper clearance at the
back and sides.
The freezer temperature is too warm.
The freezer may not be plugged in at the wall outlet.
The lid was opened too frequently or too long.
There is excessive frost built-up around the lid or a
package may be holding the lid open.
The cold control knob is set too low or is set in the off
position.
The unit may need to be defrosted.
The freezer temperature is too cold.
The cold control knob is set on too high a number.
Foods are drying out.
Packages are not properly wrapped or sealed.
Moisture is collecting on the outside of the cabinet
or lid.
Extended hot and/or humid weather will cause this
collection of moisture to occur.
The freezer lid won't fully close.
A package may be holding the lid open.
There is excessive frost built-up
The freezer clicks and does not run.
The power to the freezer has recently been disrupted
and then restored Unplug the freezer for 30 minutes
to allow the refrigeration system to equalize
Noisy operation or vibration.
The floor may be weak causing the freezer to vibrate
when the compressor is on. Placing 2" x4" boards
under the length of the freezer will help support it and
reduce the noise vibration.
The cabinet is not positioned solidly on the floor. Use
shims to correct for an uneven floor.
There is uneven food distribution in the freezer.
Redistribute the food in a uniform manner.
Excessive frost build-up.
The lid was opened too frequently or too long.
A package may be holding the lid open.
Extended hot and/or humid weather.
-8-