To Clean Agitator; To Replace Belt; Agitator Assembly - Kenmore 116.21614 Use & Care Manual

TO
CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um cleaner, the agitator must be cleaned
every time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
Clean Agitator
every week
every month
every 2 months
IMPORTANT
Disconnect vacuum cleaner from electrical
outlet. Check and remove hair, string and
lint build-up frequently in the PowerMate
agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
ore emov
any string or
debris located
on the agitator
or end caps.
AGITATOR ASSEMBLY
TO REPLACE BELT
NOTE: Use replacement belt STYLE CB-3,
see part number detail in REPLACEMENT
PARTS (page 5).
1. Install new
belt over
motor drive,
then over belt
path.
2. Place agi- _\_/_._ Drive
tarot assem- \ "_'-,_/_ BeffPath
bly back into Agitator End Cap
PowerMate.
3. Verify that end
cap is pressed
firmly into position.
3. Line up front of cover and base. Rest
cover on front edge of base as shown.
Covel
Side Rear
4. Rotate cover
back. Press cover
firmly until side
and rear latches
snap into place.
Make sure there is no gap between the
cover and base.
5. Turn PowerMateupside down and
replace two (2) cover screws.
- 24 -