Light Bulb Changing - Kenmore 116.21614 Use & Care Manual

LIGHT BULB CHANGING
_WARNING
Electrical Shock Or Personal injury
Hazard
Turn off and unplug vacuum deaner
before performing maintenance to the
vacuum cleaner. Failure to do so could
result in electrical shock or personal
injury From the vacuum cleaner
suddenly starting.
NOTE: Use replacement bulb number 20-
5248, see part number detail in REPLACE-
MENT PARTS (page 5).
1. Remove PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING (page 23-24) section.
2. Remove the light
bulb by pulling
straight out.
CAUTION
Do not plug in or turn on until the vacuum
CAUTION
_ Push in
to right
3. To replace the
light bulb, care-
fully insert fully
into slot.
4. Reinstall PowerMate cover as shown in
BELT CHANGING AND
AGITATOR CLEANING (page 23-24)
section.
AGITATOR SERVICING
WARNING
Electrical Shack Or Personal Injury
Hazard
Always turn off and unplug vacuum
cleaner before performing maintenance
to the vacuum cleaner. Failure to do so
could result in electrical shock or personal
injury from vacuum cleaner suddenly
starting.
New Brushes Worn Brushes
Bose
Support
Bar
- 25
TO CHECK THE BRUSHES
When brushes are worn to the level of the
base support bars, replace the agitator
assembly.
TO REPLACE AGITATOR
ASSEMBLY
1. Remove PowerMate cover, belt and
agitator assembly.See "To Remove Belt" in
BELTCHANGING AND AGITATOR
CLEANING (page 23-24).
2. Replace agitator assembly. See your
separate repair parts list for part number.
3. Reinstall belt and PowerMate cover. See
"To replace belt" in BELT CHANGING AND
AGITATOR CLEANING (page 23-24).