Kenmore 67277 Owner's Manual page 5

, Snaphandle trimintoplace° R eplace 4 button 9,
plugsinempty mounting holes
Handle trim -_ |
:
:1
Screw-_ 4!
Handle --,
Screw --_: Button /
Handle trim i-*] plugs \\
\
2. Remove top hinge cover° Top hinge cover snaps off.
Remove top hinge and hinge shim using hex nut
driver,
3. Remove refrigerator door by lifting off of center hinge
pin.
4, Remove center hinge pin using hex nut driver,,
5, Remove freezer door by lifting door off bottom hinge
An internal support rod may slide out of hinge socket.,
Replace rod before hanging door
6., Remove center hinge bracket and hinge shim using
Phillips screwdriver
7 Remove toe grille and bottom hinge cover° Both snap
off
8 Remove bottom hinge and hinge shim using hex nut
driver.,
E_
5/16" screws ,_,, ;
Top hinge _ , --
5/16" '.... Center hinge
hex pin
.4 hinge
Center hinge / "._ } bracket
Phdhps screws -,'
Bottom hinge f<_ :-;_:L.._ i
3/8"
screws _-------_ I:; _
Remove freezer door handle.
• Pry up back edge of handle cap using a putty knife
with the blade covered in masking tape Remove
handle cap from handle. Remove handle from door
by removing mounting screw at each side of
handle,
o Pry two button plugs from hinge side of door using
a putty knife with the blade covered in masking
tape.
:_ /Handle
" __:z_=_ Screws
, \
i
Freezer
handle
Button
plug
10 Reverse doors as necessary by performing the
following steps:
- Remove button plugs from opposite side of
refrigerator cabinet using putty knife covered with
masking tape, Insert button plugs in holes left from
hinge removal,
• Replace internal support rod in hinge side of
freezer door prior to hanging door,
Support
rod
J
11, Rehang doors by replacing bottom, center, and top
hinges, along with freezer and refrigerator doors on
opposite side of refrigerator performing steps 2-8 in
reverse order.
• Use a penny at top to space door 3/4"(18 ram)
from cabinet,