Freezer Features; Frost-Free System; Automatic Ice Maker (Some Models); Ice Service Rack - Kenmore 67277 Owner's Manual

Freezer Features
Frost-Free System
The refrigerator and freezer sections are completely
frost-free Defrosting is automatic under normal
conditions,, Refrigerator and freezer sections never have
to be defrosted
Automatic Ice Maker (some models)
• Make sure ice bucket is in place and ice maker arm
is down,,
- !!
• After freezer section reaches normal temperature,
the ice maker fills with water and begins operating.
Allow 24-48 hours after installation before first
harvest of ice Ice maker produces 7 to 9 harvests of
ice in a 24-hour period under ideal conditions,
• After ice is formed, ice maker drops ice cubes into
ice storage bucket. During ice production, ice maker
arm raises and lowers When ice storage bucket is
full, ice maker arm turns ice maker off:
Note: Discard first 3 harvests of ice so any impurities teft
in the water line after installation are not consumed.
If you wish to stop automatic ice production lift ice
maker arm. A definite click is heard when proper
position is reached Ice maker' arm will remain in that
position until pushed down..
Ice Service Rack (some models)
Install ice service rack by completing the following steps
using a Phillips screwdriver:
1. Loosen screw and washer on freezerside wall.
2. Place ice service rack on washers and slide down..
3.. Tighten screws and washers
Move ice service rack by completing the following steps
using a Phillips screwdriver:
1. Remove ice service rack by lifting rack off washers,
then pulling out.
2. Remove screws and washers that support ice service
rack. Remove plugs from freezer wail opposite ice
service rack. Replace plugs with screws and
washers, insert plugs in holes remaining from
removal of screws and washers.
3 Replace ice service rack by placing rack on washers
and sliding down until secure..
/ Ice serv ce
....... ! ,z" rack
]
CAUTION: Make sure shelf is secure before /
placing items on shelf to avoid property damage_
/
12