Table of Contents
Advertisement
Important Safety Instructions
GROUNDING
INSTRUCTIONS
See the INSTALLATION INSTRUCTIONS packaged with this rangefor complete installation and grounding instructions.
For
personal
safety,
the range must be
properly
grounded.
For maximum
safety,
the power cord must be
plugged
into an electrical
outlet that is
correctly
polarized
and properly
grounded.
Important
Safety
Notice
The California
Safe
Drinking
Water
and Toxic
Enforcement
Act requires
the Governor
of California
to publish
a list of substances
known
to the state
to cause
cancer,
birth
defects
or other
reproductive
harm,
and requires
businesses
to warn
customers
of
potential
exposure
to such
substances.
Conversion
to Liquefied
Petroleum
Gas (or L.P. Gas)
The natural gas range is designed to allow for conversion to
Liquefied Petroleum (L.P.) Gas.
If L.P. conversion is needed, contact 1-800-4-MY-HOME®for
assistance. The L.P. Conversion Kit is provided with this range
and is located on the left lower REAR (back side) panel of the
range. Before installing the kit be sure to follow the LP.
Installation Instructions carefully.
Personal injury or death from electrical
shock may occur if the range is not installed by a
qualified installer or electrician.
Any additions, changes or conversions
required in order for this appliance to satisfactorily
meet
the application needs must be made by Sears Service.
Z
Before Using Your Range
Assembly
of Burner Heads, Caps & Grates
,,_
Your range is shipped with the Burner Heads and Burner Caps in the correct locations.
Packing material is located between
'_....
the Burner Heads and Burner Skirts.
1. Be sure to follow the Installation Instructions before
installing and using your new range.
2. Remove all packing tape from cooktop area. Remove all
Burner Caps and Burner Heads.
3. Discard all packing material located under Burner Heads.
4. To replace Burner Heads and Caps, match the letters
located under center of Burner Caps with the letters
located inside Burner Heads (Fig. 1).
5. Match the letters stamped on Burner Skirts with Burner
Heads and Burner Caps (See Fig. 1). Replace the Burner
Heads and Caps on cooktop (See Fig. 2). Carefully align
the Electrodes into slot of each Burner Head (Fig. 3).
Note: The Burner Heads should sit flat on Cooktop Burner
Skirts.
6. Unpack Burner Grates and position on the cooktop.
, c%ner
Fig _
Fig. 2
ii
align into slot of each Burner Head
Fig. 3
Advertisement
Table of Contents
