Before Using Your Range - Kenmore ELITE 790.7943 Series Use & Care Manual

Before Using Your Range
Assembly of Burner Heads & Burner Caps (for Deep Well Cooktop models only)
Your appliance is shipped with the Burner Heads and Burner Caps in the correct locations. Packing material is located
between the Burner Heads and the cooktop.
a. Be sure to follow the installation instructions before
installing and using your new appliance.
b. Remove all packing tape from cooktop area. Remove all
Burner Caps and Burner Heads.
c. Discard all packing material located under Burner Heads.
d. To replace Burner Heads & Caps, match the letters
located under center of Burner Caps with the letters
located inside Burner Heads (Fig. 1).
e. Match the letters stamped on Burner Skirts with Burner
Heads and Burner Caps (See Fig. 1). Replace the Burner
Heads and Caps on cooktop (See Fig. 2). Carefully align
the Electrodes into slot or hole of each Burner Head (Fig.
3). Note: The Burner Heads should sit flat on Cooktop
Burner Skirts.
f. Unpack Burner Grates and position on the cooktop.
Burner
Cap
Fig. 1
Fig. 2
Electrode
must align into slot or hole
for Simmer Burner Head
Fig. 3