Before Using Your Range; Assembly Of Burner Heads, Caps & Grates - Kenmore 7755 - Elite 30 in. Dual Fuel Range Use And Care Manual

important Safety instructions
GROUNDING iNSTRUCTiONS
See the INSTALLATION INSTRUCTIONS packaged with this range for complete installation and grounding instructions.
For personal safety, the range must be properly grounded. For maximum safety, the power cord must be plugged into an electrical
outlet that is correctly polarized and properly grounded.
Important Safety Notice
The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of
substances known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn
customers of potential exposure to such substances.
Before Using Your Range
Assembly of Burner Heads & Burner Caps
Your range is shipped with the Burner Heads and Burner Caps in the correct locations, Packing material may be located
between the Burner Heads and the cooktop.
The following instructions apply to all burners except the
right front double burner. For assembly instructions for the
double burner see the General Care & Cleaning section.
a. Be sure to follow the installation instructions before
installing and using your new range.
b. Remove all packing tape from cooktop area. Remove all
Burner Caps and Burner Heads.
c. Discard all packing material located under Burner Heads.
Please note: Models with a right front double ring burner
are not marked with letters
d. To replace Burner Heads & Caps, match the letters
located under center of Burner Caps with the letters
located inside Burner Heads (Figs. 1 & 2).
e. Match the letters stamped on Burner Skirts with Burner
Heads and Burner Caps (See Fig. 1). Replace the Burner
Heads and Caps on cooktop (See Fig. 2). Carefully align
the Electrodes into slot of each Burner Head (Fig. 3).The
Burner Heads should sit flat on Cooktop Burner Skirts..
f. Unpack Burner Grates and position on the cooktop.
All other models
Burner "::_'P 2)_!'_!;_\
Head / _b_:_ f::;_: :_ :;j_:/iJj
ode
Fig. 1
: L:::::
_ Fig. 2
Electrodes must
lign into slot for each Burner
Fig. 3 Head
iii ............
.......... iii .........
Conversion to Liquefied Petroleum Gas (or L.P. Gas)
The natural gas range is designed to allow for conversion to
Liquefied Petroleum (L.P.) Gas.
Please note: Models equipped with a double right front gas
burner are not L.P. Convertible.
If L.P. conversion is needed, contact your local L.P. gas
provider for assistance. The L.P. Conversion Kit is provided
with this range and is located on the left lower REAR (back
side) panel of the range. Before installing the kit be sure to
follow the L.P. Installation Instructions carefully.
Personal injury or death from electrical
shock may occur if the range is not installed by a qualified
installer or electrician.
Any additions, changes or conversions
required in order for this appliance to satisfactorily meet the
application needs must be made by Sears Service.