Starting Your Washer - Kenmore Electronic Three-Speed Automatic Washers Owner's Manual & Installation Instructions

STARTING YOUR WASHER
STEP 1. Place a load of sorted clothes
in the washer. Add measured detergent
directly into dispenser (details on
page 34).
STEP 2. Add measured liquid chlorine
bleach to the liquid chlorine bleach
dispenser, if desired (details on page 35).
STEP 3. Add measured liquid fabric
softener to the fabric softener dispenser,
if desired (details on page 36).
STEP 4. Close washer lid.
STEP 5. Select the cycle you want by
pressing one of the pads under SELECT
CYCLE O (details on pages 27-28). This
will turn the washer display on.
STEP 6. (OPTIONAL STEP) If desired,
set OPTIONS O for your wash by press-
ing the pads for CATALYST
TM,
SOAK
and/or RINSE OPTIONS (details on page
28-29).
STEP 7. Select the WATER LEVEL _),
WASH/RINSE TEMP _1, AGITATION
TIME O, and/or DELAY START((_), and
SIGNAL _) settings that are indicated
on your MODIFIERS (_ display (details
on pages 29-32).
STEP 8. Press START O. The wash
cycle will begin. The ESTIMATED TIME
REMAINING will be displayed,
NOTE: If you do not press START within
5 minutes of selecting the cycle, the
washer will automatically shut off.
PAUSING/RESTARTING
YOUR WASHER
• To pause the washer at any time, press
STOP/CANCEL 0.
• To restart the washer, close the lid and
press START O.
Q
MOOIR_
'='- ]
........ @O
24