Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle - Kenmore 665.15922 Use & Care Manual

IM
Use this cycle for pre-
rinsed or lightly-soiled
loads, This cycle
automatically adds a fill
Use main detergent
and brief pre-wash, dispenser section.
purging the hot water line
and improving wash
results, without adding
time for water heating
periods,
Initial display time: 48 min
First Fill Wash Main Rinse Rinse Final Dry Time Water
Usa e
TempWater Wash Heated Rinse (rain) (gel _gq)/L
Greater O • _ _ 48* 5.2-6,7/
than 19,7-25,4
135°F
(57°C)
Less _ _ O _ _ 44* 6.9-8,4/
than 26,1-31,8
135°F
(57°C)
During the first fill of a cycle
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
After the first fill of a cycle
1. Press
The display shows
@_ Use this rinse cycle for rinsing 1_£
CK_ dishes, glasses, and silverware
gl that will not be washed right
DO not use
away,
Initial display time: I 0 min detergent with
this cycle.
Wash Main Rinse Rinse Final Dry Time Water
Wash Heated (min) Usage
Rinse (gel/L)
10 1,8-2,1/
6.8-7.9
NOTE: The sensor in your dishwasher monitors the soil level,
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance,
Anytime during a cycle, press
The display shows
Your dishwasher starts a 2 minute drain (if needed), Let the
dishwasher drain completely, The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. Close the door,
4. Press a new cycle and/or options.
5. Press START,
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items,
To add items
1. Lift up the door latch to stop the cycle, Wait for the spraying
action to stop before opening the door,
2. Open the door. If the detergent dispenser cover is still closed,
add the item,
3. Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5 second pause,
Your dishwasher starts a 2 minute drain (if needed), Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off, Select a new cycle and options.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately,
Remember to drain the dishwasher before starting a new cycle,
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear all
options and cycles.
14