Kenmore 385.16520000 Owner's Manual page 94

Automatic Buttonhole (Continued)
(_) Guide slot
® Guide block
Buttonhole guide plate
(_ Buttonhole template
(_) Catch
@ Setting mark
(_ Gear
(_ Base plate
After you select a template Owith the style and size of
buttonhole, slide the template into the guide plate (_)o Pull
the catch (_)toward you while sliding the template (_)until
the selected buttonhole is at the setting mark (£)o Insert the
gear of base plateOinto the guide slot of templateOand
fit the guide block® into the center of the guide slot..
f
I
t
(T) Needle thread
® Bobbin thread
(_ Buttonhole foot
QGear
(g) Slot
(_ Starting point
Attach the buttonhole foot (_). Adjust the position of gear_
so it is aligned with the starting point of the template (_).
The lever can be used to change gear positions. Pull the
bobbin thread up through the guide slot of the buttonhole
guide plate by turning the handwheel counterclockwise
while holding the needle thread., Place the bobbin and
needle threads to the left side of the guide plate.. Leave 3"
to 4" (7°0 to 10..0 cm) of thread,
f-
@
®
J
!
86