General Information
Your system may be set up so that certain lights or other devices can be turned
on or off by using the #70 command from either a keypad or a telephone keypad
(if 4286 VIP module is used). Ask your installer if this has been done in your
system.
To activate relays from a keypad, enter 4-digit security code +
Follow the keypad prompts described below.
To activate relays using a telephone and 4286 VIP module, first dial the 2-
digit phone access code. When the system acknowledges the access, enter 4-digit
security code + # + 70. The following prompts/voice responses will begin.
ENTER DEVICE NO.
00=QUIT
NN
HIT 0=OFF , 1=ON
NN
HIT THE "✴" KEY
Using #70 Relay Menu Mode
Voice: "ENTER DEVICE CODE NOW"
01
Enter the 2-digit number of the device to be
activated.
Note that if an invalid number is entered, the
system will simply ask you to reenter the number.
DEVICE IS OFF
Voice: "voice descriptor DEVICE nn ON/OFF. FOR
voice descriptor ON ENTER 1, FOR voice descriptor
OFF ENTER 0"
Press 0 or 1 to turn the device off or on respectively.
"nn" represents the 2-digit device number and voice
descriptor is the relay voice descriptor programmed
by the installer.
DEVICE IS OFF
Voice: "voice descriptor DEVICE nn ON/OFF. TO
EXIT ENTER 00 NOW"
From a keypad, press ✴ to continue. The ENTER
DEVICE NO. prompt will appear.
From a telephone keypad, enter 00 to exit, or
enter the next relay number to be programmed. The
current on/off state of that relay will be
annunciated as described above. Alternatively, if 6
seconds elapses with no key depression, the 4286
VIP module will annunciate the "ENTER DEVICE
CODE NOW" message.
#
+70.
– 47 –