Disarming And Silencing Alarms; Using The 1 Off Key; Memory Of Alarm - Honeywell VISTA-128BPTSIA User Manual

Commercial burglary partitioned security system with scheduling

Hide thumbs Also See for VISTA-128BPTSIA:

Quick manual (2 pages)

Installation and setup manual (124 pages)

Programming manual (105 pages)

Table Of Contents

Table of Contents

Using the 1 OFF Key

The OFF key is used to disarm the system and to silence alarm and trouble

sounds. See "SUMMARY OF AUDIBLE NOTIFICATION" section for

information which will help you to distinguish between FIRE and

BURGLARY alarm sounds.

IMPORTANT: If you return and the main burglary sounder is on, DO NOT enter the

premises, but call the police from a nearby safe location. If you return after an alarm has

occurred and the main sounder has shut itself off, the keypad will beep rapidly upon

entering, indicating that an alarm has occurred during your absence. LEAVE

IMMEDIATELY and CONTACT THE POLICE from a nearby safe location.

To disarm the system and silence burglary or fire alarms:

1. Enter your security code and press

2. The Ready message will be displayed (if no alarms have occurred while

armed) and the keypad beeps once to confirm that the system is disarmed.

IMPORTANT:

the system when it is in entry delay or alarm. Entering a valid user code alone causes

the system to disarm. All other times pressing the "OFF" key is needed. This is a SIA

CP-01 requirement.

If an invalid code is entered to silence an alarm condition, the keypad stops beeping

for 10-15 seconds. If a valid code is not entered during the 10-15 seconds, the keypad

resumes beeping.

Memory of Alarm

The keypad displays the zone number and type of alarm for any zone that

has an alarm condition. These messages will remain displayed until cleared

by a user. If an alarm has occurred, note the zone number displayed on the

keypad and repeat step 1 above to clear the "Memory of Alarm" and restore

the Ready message display. If the Ready message does not display, go to the

displayed zone and remedy the fault (close windows, etc.). If the fault cannot

be remedied, notify the alarm agency.

If the system was armed when the alarm occurred, repeat step 1 twice: once

to disarm the system, a second time to clear the display.