Arming Perimeter Only; (With Entry Delay On); Using The 3 Stay Key - Honeywell VISTA-128BPTSIA User Manual

Using the 3 STAY key

Use this key when you are staying home, but might expect someone to use
the entrance door later.
When armed in STAY mode, the system will sound an alarm if a protected
door or window is opened, but you may otherwise move freely throughout the
premises. Late arrivals can enter through the entrance door without causing
an alarm, but they must disarm the system within the entry delay period or
an alarm will occur.
The system provides three STAY modes. STAY mode 1, 2, and 3. STAY
modes 1 and 2, when activated automatically bypass specific zones assigned
by your installer to each of the STAY modes. If there are only Stay 1 zones,
entering Code+Stay[3] will automatically arm in Stay Mode 1; however if
there is at least one zone assigned to Stay Mode 2, you MUST enter either
Code+[3]+[1], Code+[3]+[2] or Code+[3]+[3], else the panel will not arm. If
Code+[3] is entered Stay Mode 1 prevails (even if there are Stay Mode 2
zones). Check with your installer for a list of the zones that are bypassed
during each STAY mode.
Close all perimeter windows and doors before arming (see
CHECKING FOR OPEN ZONES section)
1. Enter your security code and press
Enter your security code and press
Enter your security code and press
2.
ARMED ***STAY 1*
ZONE BYPASSED

Arming Perimeter Only

STAY
3 + 1 for STAY Mode 1.
+ 2 for STAY Mode 2.
3
+ 3 for STAY Mode 3.
3
The keypad beeps three times, displays the
armed message, and indicates which STAY
mode (1, 2 or 3).
Note: "ZONE BYPASSED" in this display
simply indicates that some zones of protection
are not armed when using STAY mode.

(With Entry Delay ON)

– 33 –