Automation - Honeywell LYNX Touch Security System User Manual

General Information
Automation is used to program triggers, home automation features, send Follow-Me or E-
mail messages of system events or program home automation features (Z-Wave) including
Rules and Scenes (if Z-Wave communications have been enabled). Up to 40 rules can be
programmed. Rules 1 through 20 are used for Triggers, Z-Wave Scenes and Follow-Me
Messages. Rules 21 through 40 are used to trigger Z-Wave Scenes and for E-mail notification
and are only accessible through TotalConnect Service. Check with your Installer to see which
options are available to you.
Note: Switches, Thermostats, Locks, Tools, and Scenes options will only appear when Z-wave has been
enabled.
Rules
The following options are programmed in this section:
Programming Field
Rule 1 - 20:
Name:
Type:
Action:
Start Zone Type:
OR
Zone Type Fault:
Stop Zone Type:
OR
Zone Type Restore:
Start System Operation:
OR
System Operation 1
Stop System Operation:
OR
System Operation 2
Zone Number Operation:
* The displayed field is dependant upon the selection made
Programming Rules
Ready To Arm
Arm Away Arm Stay
Delay 10:18 AM June 8, 2010
Select Rule 1 -20
Note: Rules 21-40 are only accessible through TotalConnect Service.
Name the device
Select the output type
Select the action required for the device
Select Zone Type to start event*
Select Zone Type to stop event*
Select System Operation to start event*
Select System Operation to stop event*
Select Zone Number to trigger event upon fault, trouble or alarm as selected.
72
Zones

Automation

Phone
Message
More
5100-100-004-V0
– 47 –
USER FUNCTIONS USER FUNCTIONS USER FUNCTIONS USER FUNCTIONS
Action
1. With the system in the disarmed state,
select the "Automation" icon from the
Home Screen. The system displays the
Keypad screen.
Automation