Honeywell LYNX Touch Security System User Manual page 27

Disarming the System During Entry Delay
Armed Stay - Disarm Now
Disarm Now
ARMED READY
Enter Code:
Cancel
When an Alarm Occurs
When an alarm has occurred, the touch screen displays the zone number(s) that caused the
alarm and the type of alarm (e.g., "Fire Alarm"). These messages remain displayed until
cleared by a user. To clear the display, note the zone number displayed and enter an Off
sequence. If the fault cannot be corrected, notify your alarm company.
Disarming the System and Silencing Alarms
Alarm
Alarm
Enter Code:
Cancel
Alarm
Alarm 2
Front Door
Disarm
4:43 PM August 11, 2011
1 2 3
4 5 6
7 8 9
Clear 0
5000-100-201-V0
1 2 3
4 5 6
7 8 9
Clear 0
5000-100-202-V0
72
Zones Automation
Message Phone
More
5000-100-203-V1
– 27 –
SECURING THE PREMISES SECURING THE PREMISES SECURING THE PREMISES SECURING THE PREMISES
Disarming the System
Upon entering the premise when the system is
armed, the control announces "disarm system
now".
1. Enter a valid Code. The system beeps
once and announces "Disarmed Ready to
Arm".
Note: If a valid user code is not entered before
the programmed entry delay occurs, the
system enters alarm mode.
1. Enter a valid Code. The system beeps
once and announces "Disarmed Ready to
Arm".
Note: If a valid user code is not entered before
the programmed entry delay occurs, the
system remains in alarm mode.
2. The zone that caused the alarm is
displayed. Enter an Off sequence to clear
the alarm. The system beeps once and
announces "Disarmed Ready to Arm".