REMOVING THE TEMPERATURE SENSOR
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug washer or disconnect power.
2.
Turn off the water supply to the washer.
3.
Remove the three T-20 hex-head torx
screws from the toe panel and remove the
panel.
Toe Panel
Screws
Heating Element & Temperature Sensor
& THE HEATING ELEMENT
4-16
4.
Use a 13/32"(10 mm) socket and loosen
the hex nut on the heating element bracket.
5.
To remove the temperature sensor:
a) Disconnect the sensor connector.
b) Pull the sensor out of the heating ele-
ment bracket hole.
Pull Out Sensor
Sensor
Connector
Ground Wire
Element Wires
6.
To remove the heating element:
a) Remove the temperature sensor (see
step 5).
b) Disconnect the element wires and the
green ground wire from the terminals.
c) Pull the heating element and tempera-
ture sensor out of the tub.
Heating
Element
Hex Nut