Tool Kit (Jack - Wheelbrace, Etc.); Wheel Trim - Renault Latitude Handbook

tOOL KIt/WheeL trIm - WheeL
1
6
5
3
4
The tool kit is located under the lug-
gage compartment carpet (tools varies
depending on the vehicle).
1 Jack
When replacing the jack, fold it cor-
rectly and position the wheelbrace cor-
rectly before replacing it in its position.
The jack is designed for
wheel changing purposes
only. Under no circum-
stances should it be used
for carrying out repairs underneath
the vehicle or to gain access to the
underside of the vehicle.
5.6
2 towing hitch
Refer to the information on "Towing" in
Section 5.
3 Screwdriver
4 hubcap tool
This tool is used to remove the wheel
2
trims.
5 nut wrench
6 Wheelbrace
Do not leave the tools un-
secured inside the vehicle
as they may come loose
under braking. After use,
check that all the tools are correctly
clipped into the tool kit, then position
it correctly in its housing: there is a
risk of injury.
If wheel bolts are supplied in the
tool kit, only use these bolts for the
emergency spare wheel: refer to the
label affixed to the emergency spare
wheel.
F
D
c
e
7

Wheel trim

Remove it using hubcap tool 4 by en-
gaging the hook in the opening pro-
vided near valve 7.
To refit the hubcap, align it with valve 7.
Push the retaining hooks in fully, start-
ing with side C near the valve, followed
by D and E, finishing at F opposite the
valve.
note: if you are using anti-theft bolts,
refer to the information on "Changing a
wheel".
4