Front Seat Belt - Renault Latitude Handbook

sEAT BELTs
(2/3)
1
3
5
Locking
Slowly pull the belt from the inertia reel
and push buckle 3 into catch 5 until
you hear a click (check that the belt
is secure by pulling buckle 3). If the
seat belt locks and refuses to unwind
enough to be buckled, pull firmly on the
belt and then release it. Then try again.
If the seat belt locks and refuses to
return, pull 3 cm of the belt out slowly,
then release it. It will retract automati-
cally. Then gently pull the seat belt out
of the inertia reel.
If there is still a problem, contact an ap-
proved dealer.
ß

front seat belt

reminder warning light
This lights up on the central display
when the engine is started then, if the
driver's or front passenger's seat belt
(if this seat is occupied) is not fastened
and the vehicle has reached approxi-
mately 12 mph (20 km/h), it flashes and
a bleep sounds for around 120 sec-
onds. Afterwards, just the warning light
is on.
Note: an object placed on the passen-
ger seat base may activate the warning
4
light in some cases.
5
Rear seat belt reminder (depending
on the vehicle)
The number of rear seat belts fastened
appears on the instrument panel for ap-
proximately 30 seconds each time:
– the vehicle is started;
– a door is opened;
– a rear seat belt is fastened or unfas-
tened.
Check that the rear passengers are
wearing seat belts and that the number
of seat belts shown as fastened cor-
responds to the number of rear bench
seats occupied.
6
Adjusting the front seat belt
height
Press button 6 to adjust the seat belt
height so that shoulder strap 1 is worn
as shown previously:
– to lower the seat belt, push button 6
and lower the seat belt simulta-
neously;
– to raise the seat belt, push button 6
upwards.
Make sure that the seat belt is locked
in position correctly after you have ad-
justed it.
1.21