Tool Kit (Jack - Wheelbrace, Etc.); Wheel Trim - Renault MEGANE Driver's Handbook Manual

tOOl KIt/wheel trIm – wheel
2
1
The tool kit is located in the luggage
compartment: lift the carpet.
The tools included in the tool kit depend
on the vehicle.
Do not leave the tools unsecured inside the vehicle as they may come
loose under braking. After use, check that all the tools are correctly
clipped into the tool kit, then position it correctly in its housing: there is a
risk of injury.
If wheel bolts are supplied in the tool kit, only use these bolts for the emergency
spare wheel: refer to the label affixed to the emergency spare wheel.
The jack is designed for wheel changing purposes only. Under no circumstances
should it be used for carrying out repairs underneath the vehicle or to gain access
to the underside of the vehicle.
5.6
wheelbrace 1
Jack 2
When replacing the jack, fold it cor-
rectly and position the wheelbrace cor-
rectly before replacing it in its position.
hubcap tool 3
This tool is used to remove the wheel
trims.
3
wheel bolt guide 4
To finish loosening or starting to tighten
4
the wheel bolts.
5
towing hitch 5
Refer to the information on "Towing" in
Section 5.
e
c
B
6

wheel trim

Remove it using the hubcap tool 3 by
connecting the hook in the recess pro-
vided next to the valve 6 (to attach the
metal clip).
To refit wheel trim, align it with valve 6.
Push the retaining hooks in fully, start-
ing with side B near the valve, followed
by C and D, finishing at E opposite the
valve.
note: if you are using anti-theft bolts,
refer to the information on "Changing a
wheel".
D