Figure 2-5. Removing The Compactflash Card - Ampro CoreModule 420 Quick Start Manual

Pc/104 single board computer

Hide thumbs Also See for CoreModule 420:

Table of Contents

Chapter 2

6. Turn the screwdriver clockwise to loosen the CompactFlash card as shown in Figure 2-5.

7. Move the screwdriver to the other slot and turn the screwdriver counter-clockwise to completely

disengage the CompactFlash card from the socket. See Figure 2-5.

8. Grasp the two sides of the CompactFlash card and gently pull it from the CompactFlash

socket/protective cover and place on anti-static surface or in anti-static bag.

9. If you are installing a new or the same CompactFlash card, skip to the Installing the

CompactFlash Card procedure.

10. If your are not re-installing a new or the same CompactFlash card continue with this procedure.

11. Turn the CoreModule 420 back over onto the bottom of the board, placing it on the work surface.

12. Reconnect any cables you disconnected earlier to turn the board over.

13. Ensure all other connections to the CoreModule 420 are still well connected.

14. Plug the power supply's power cord into the AC power source and restore power.

CoreModule 420

2nd

Turn

Counter-

Clockwise