Table of Contents
Advertisement
Chapter 1
18) Enter BIOS Setup Utility
19) Alter Boot Order, only if
needed.
a) Select the BIOS and Hardware
Settings menu as shown in the
figure to the right and press
Enter.
The sub-steps listed here
show you how to change the
Boot Sequence while in the
BIOS Setup Utility.
b) Select the first drive in the Boot
Order as highlighted to the right.
This example assumes Drive A
is a 3 ½" floppy drive, Drive C is
an IDE HDD, and the 3
an IDE CD-ROM.
NOTE
The CD-ROM or
CompactFlash (CF) must
be listed in Drive
Assignment and the Boot
Order to be recognized by
the BIOS. CF can only
be listed as C or D drive
in the Boot Order.
c) Move the CD-ROM up in the
Boot Order.
d) Exit and Save changes.
20) If using a CompactFlash
CoreModule 420
• Press the <Del> key during POST, or S to enter BIOS Setup.
• Use BIOS Setup during the initial boot to set the desired options
(time and date, alter the boot drive for the floppy drive, CD-
ROM, or hard disk drive, etc.).
• Refer to the next step to alter the boot sequence, while in Setup.
• If you need to alter the boot sequence to select a bootable device,
perform the items listed in this step.
>
[Drive Assignment]
Drive A
rd
drive is
Drive B
Drive C
Drive D
Drive E
[Boot Order]
> Boot 1st
Boot 2nd
Boot 3rd
Boot 4th
Boot 5th
Boot 6th
[Drive and Boot Options]
• Use the Arrow keys and PU/PD keys to move the CD-ROM
up in the Boot Order.
• If you want to keep the floppy drive and hard drive in the boot
order, you will need to make changes to the other Boot Order
devices.
For example, change Boot 3
boot sequence.
• If you did not receive a CompactFlash card from Ampro, go to
the next step, Step 21.
• If you received a CompactFlash card from Ampro with your
system, use the compact flash card to boot the system.
• If you have to change the boot order to do so, refer to Step 19.
• If you do not intend to install the OS or additional drivers onto
the hard disk drive, skip Step 21. See jumper setting next page.
QuickStart Guide
Ampro Setup Util
BIOS and Hardware Settings
Reload Initial Settings
Load Factory Default Settings
Exit, Saving Changes
Exit, Discarding Changes
Ampro Setup Utility for CoreMod
1.44 MB, 3.5"
HDD on Pri Master
CDROM on Pri Slave
rd
to Drive A, to keep it in the
Setting Up the EnCore 420
<
(none)
(none)
Drive A: <
Drive C:
CDROM
(none)
(none)
(none)
9
Advertisement
Table of Contents
