Projector Body - Panasonic PT-DZ13KU Operating Instructions Manual

Note
f The remote control can be used within a distance of about 30 m (98'5") if pointed directly at the remote control signal receiver. The remote
control can control at angles of up to ±15° vertically and ±30° horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f The power indicator <ON (G)/STANDBY (R)> will flash if the projector receives a remote control signal.

Projector body

Front
1 2 3 4 5
6 7
Rear
8
Bottom
Projection direction
Chapter 1 Preparation — About your projector
6
9 8 10
18 14
Side
11 12
SDI 1/2
14
WARNING
Keep your hands and other objects away from the air
exhaust port.
f Keep your hands and face away.
f Do not insert your fingers.
f Keep heat-sensitive objects away.
Heated air from the air exhaust port can cause burns, injury, or
deformations.
1 Power indicator <ON (G)/STANDBY (R)>
Displays the status of the power.
2 Lamp indicator <LAMP1>
Displays the status of lamp 1.
3 Lamp indicator <LAMP2>
Displays the status of lamp 2.
4 Temperature indicator <TEMP>
Displays the internal temperature status.
5 Filter indicator <FILTER>
Displays the status of the air filter unit.
6 Adjustable feet
Adjusts the projection angle.
7 Remote control signal receiver (front)
8 Air exhaust port
9 Lamp unit cover
10 Remote control signal receiver (rear)
11 Control panel (x page 26)
12 Connecting terminals (x page 27)
13 14
15 16
17 14
ENGLISH - 25