[Lamp Power]; [Brightness Control] - Panasonic PT-DZ13KU Operating Instructions Manual

[LAMP POWER]

Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
1) Press as to select [LAMP POWER].
2) Press qw to switch the item.
[HIGH]
*1
[MIDDLE]
*1
[NORMAL]
*2
[ECO]
*1 Only for PT-DZ13KU, PT-DS12KU, PT-DW11KU
*2 Only for PT-DZ10KU
Note
f You can reduce power consumption and operation noise, and extend the life of the lamps by setting to [MIDDLE] rather than [HIGH], or by
setting to [ECO] rather than [MIDDLE] or [NORMAL].

[BRIGHTNESS CONTROL]

The projector is equipped with a luminance sensor to measure brightness and functions to correct screen brightness resulting from changes in
lamp brightness.
Use the projector when using multiple projectors to display on multiple screens to reduce changes in overall brightness of the multiple screens
due to lamp degradation and suppress variation in brightness to preserve uniformity.
Setting [BRIGHTNESS CONTROL GAIN]
Adjust the brightness when displaying multiple screens using multiple projectors.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [BRIGHTNESS CONTROL GAIN].
4) Press qw to adjust.
Operation
Press the w button.
Press the q button.
Note
f When using only one projector, the value obtained by subtracting the value of the [BRIGHTNESS CONTROL GAIN] from 100 % is the
maximum amount of brightness correction. Brightness cannot be corrected through brightness control since the maximum amount of
correction becomes 0 % when [BRIGHTNESS CONTROL GAIN] is at 100 %.
f Luminance will be unsteady for eight minutes after a lamp is turned on. Make adjustments at least 8 minutes after starting projection.
f The result of [BRIGHTNESS CONTROL GAIN] adjustments is reflected on all image signals, internal test patterns, and on-screen menus.
f The [BRIGHTNESS CONTROL GAIN] setting is enabled even if [BRIGHTNESS CONTROL SETUP] is [OFF].
Setting [BRIGHTNESS CONTROL SETUP]
Set brightness control operation.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [BRIGHTNESS CONTROL SETUP].
4) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL SETUP] screen is displayed.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select when high luminance is required.
Select when using the projector with slightly reduced luminance compared to [HIGH].
Select when high luminance is required.
Select when high luminance is not required.
Brightness
The screen becomes brighter.
The screen becomes darker.
Adjustment
Maximum amount of
brightness correction
The maximum amount of
correction is reduced.
The maximum amount of
correction is increased.
Range of adjustment
20 % - 100 %
ENGLISH - 111