Connecting Machine; Installing Machine Head; Sewing Light - Kenmore 16 Instructions Manual

0
o I
I,
\
\
0 0
i_ _...:f i,.-g,#TAi
:-. _--t ii_ Hf'..Gf
INSTALLING MACHINE HEAD
Loosen the two hinge screws under holes in the
rear edge of the machine bed (1).
Raise hinge pins in the cabinet cutout (2].
Slip machine head onto the pins and tighten hinge
screws securely (3].
Lower machine head to front flap.
Screw spool pins in place. Lay the plastic discs
over the spool pins. Discs and pins are packed in
the accessory box.
SEWING LIGHT
The sewing light is located inside the face cover
plate as shown. It may be turned on or off by
pushing the light switch. In order to operate the
machine the switch must be on.
To remove bulb, turn light switch off, open the
face cover plate by swinging it open, push bulb in
slightly, turn bulb clockwise, and remove from
socket. To replace push in new bulb and turn
counter clockwise. See illustration 4.
CONNECTING MACHINE
Push the plug onto three-prong connector under
the bed plate. Plug machine cord into any l10-
120V wall outlet. See illustration 5.